Dealer Network Home
Dealer Network Home    DNet-KM.com    DNet-KM.com  Hop To Forum Categories  Making The Connection    CAD Master Mother Board
Go
New
Find
Notify
Tools
Reply
  
CAD Master Mother Board
 Login/Join 
Full Member
Picture of Kwelch
Posted
Can you use a plain computer mother board or do you have to buy the one from Kyocera? If you can use a regular mother board, is it an ATX?
 
Posts: 35 | Location: Granger, IN | Registered: July 07, 2004Reply With QuoteReport This Post
Senior Member
Picture of bilyzoom
Posted Hide Post
There was a similar post on this in the B&W section titled 'KM-4850w' a few months ago.
 
Posts: 243 | Location: So. Cal. | Registered: October 18, 2007Reply With QuoteReport This Post
Full Member
Picture of Kwelch
Posted Hide Post
But no response?
 
Posts: 35 | Location: Granger, IN | Registered: July 07, 2004Reply With QuoteReport This Post
Senior Member
Picture of bilyzoom
Posted Hide Post
Posted April 04, 2011 10:49 AM Hide Post
Its done!

Old - MSI Motherboard MS-6340 Ver 1
Old - AMD Duron 850mhz Processor
New - Tenda L8139 PCI LAN Card
Old - 40GB Seagate HDD

Ghosted and booted first time!
They just have a separate push button now to start the unit manually..


... just had to share that success...

Mark.
 
Posts: 243 | Location: So. Cal. | Registered: October 18, 2007Reply With QuoteReport This Post



  Powered by Social Strata  
 

Dealer Network Home    DNet-KM.com    DNet-KM.com  Hop To Forum Categories  Making The Connection    CAD Master Mother Board

© 2002-2012 Dealer Network
home | about | rules | donation | message board | contact