I have a C-3232E getting J-18's from LCC jam sits behind left copier bottom side door, so far I have replced vertical conveying clutches, timing switches, and I'm going to do the modified side door, although I tried doubling up the springs allready. Is there something I'm missing, I have fixed this problem in the past with clutches. Thanks in advanced Skyshot

Just a point. Have you checked the conveyor section in the LCC. You know, the plastic stopper for the clutch. The bit that breaks. It is easy to tell,, if the paper feed is making a noise when feeding. This causes phantom jams....

there is a bullitain for that isue does the lower door assy have two springs on the idlers or single spring in the middle of the idler shaft there is a updated part for j-18

Do you have the tech bulletin? I have looked for it on KMA Connect and can't find it.

bulletin number 8433/2fz-0103 part numbers are - 302fz93312 cover assy, 302jd22010 film, 302fz04763 springs

The door worked for me on two seperate machines after doing the vertical clutches and timing switches