I have two voyagers in the field doing the same thing. Toner is building up on the cyan and magenta drum units. the augers are working, I've put new drums and transfer belt, updated firmware, cln and vac. The build up causes voids and streaks. Any help would be appreciated.

check the motor for the particular units...the are about to fail...good luck..



DUMMIETEK...dont bite the hand that feed u...

Not to sound like a dufus, but what models are Voyagers, Falcons, etc?

Falcon One 2530, 3530, 4030

Falcon Two 3035, 4035, 5035

Voyager (E or non-E) C2520, 3232, 3225

Harrier 2560?

Saturn ?

Our Kyo-Geeks will let you know by tomorrow.

On one of the two machines, the rear drive pack had been replaced. Not sure if this is related, but I have noticed a build up of toner on the magenta dev unit lining up perfectly where the calibration 'id patch' is developed on the transfer belt. This build up of toner is multi colored.

quote:

Originally posted by lifer:
On one of the two machines, the rear drive pack had been replaced. Not sure if this is related...

I'm finding that the useful life of the main drive pack is less than 1M, closer to 3/4M prints. It's just not worth changing out individual gears when they're all worn. =^..^=